User's Manual

* Emulex LPm16002 Dual Port FC16 HBA Mezzanine

• H310 Adapter

• H310 Mini Monolithic

• H310 Mini Blades

• H310 Embedded

• H710 Adapter

• H710 Mini Blades

• H710 Mini Monolithic

• H710P Adapter

• H710P Mini Blades

• H710P Mini Monolithic

• H810 Adapter

• PCIe Adapter

• PCIe Backplane

Integrated Broadcom NICs are controlled by both BIOS and the settings stored on the device itself. As a result, the Boot

Protocol field in the HII of integrated NICs has no effect; this setting is instead controlled by the BIOS on the Integrated

Devices screen. To set integrated NICs to an iSCSI or PXE boot mode, select System BIOS Settings, and then select

Integrated Devices. In the list for each embedded NIC, select the appropriate value— Enabled for no boot capability,

Enabled with PXE to use the NIC for PXE boot, or Enabled with iSCSI to use the NIC to boot from an iSCSI target.

Modifying Device Settings

To modify device settings by using the Advanced Hardware Configuration:

NOTE: You can also modify the device settings by using the System Setup utility during startup. For more

information about the System Setup utility, see the Using The System Setup Program And Boot Manager chapter in

this User's Guide.

1. In the left pane, select System Setup.

2. In the right pane, click Advanced Hardware Configuration.

3. Select the device you want to configure.

Depending on the configuration setting changes, the following message may be displayed:

One or more of the settings requires a reboot to be saved and activated. Do

you want to reboot now?

4. Select No to continue making additional configuration changes.

All changes are applied during the next system boot.

Collect System Inventory on Restart

When you enable the Collect System Inventory On Restart property, hardware inventory and part configuration

information is discovered and compared with previous system inventory information on every system restart.

Updating Server Inventory Information

To enable collecting system inventory on restart:

1. In the left pane, click Hardware Configuration.

2. In the right pane, select Hardware Inventory.