User's Manual
The System Setup Main Menu page is displayed.
2. In the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings page is displayed.
3. Click Lifecycle Controller.
4. Under Cancel Lifecycle Controller Actions, select Yes.
5. Go back to the System Setup Main Menu page and click Finish to save the settings.
6. Click Yes to reboot the system.
Using Lifecycle Controller for the First Time
After you launch Lifecycle Controller for the first time, by default the Settings → Language and Keyboard page is
launched. However, the Home page is launched after subsequent launches.
1. By default, the Language and Keyboard Layout are English and United States. To change language and keyboard
layout, select the Language and Keyboard Layout, and click Next.
The Network Settings page is displayed.
2. Configure the network settings, and click Finish.
3. It is recommended that you run the Firmware Update wizard, and apply the required updates.
Related Links
Setting Up Lifecycle Controller
Updating Firmware
Setting Up Lifecycle Controller
Use Settings wizard to specify the language, keyboard layout, and network settings for Lifecycle Controller only. This
does not change the system or other application settings.
Specifying Language and Keyboard Type
1. In the left pane, click Settings.
2. In the right pane, click Language and Keyboard. Use the up-arrow and down-arrow keys to select the options.
– From the Language drop-down list, select the language.
– From the Keyboard Type drop‑down list, select the keyboard type.
3. Click Finish to save the new settings.
Configuring Network Settings for a NIC
1. In the left pane, click Settings.
2. In the right pane, click Network Settings.
3. From the NIC Card drop-down list, select the NIC card that you want to configure.
4. From the IP Address Source drop-down list, select one of the following options:
NOTE: The IP Address Source function supports only IPv4.
– No Configuration — Does not configure the NIC.
– DHCP — Obtains an IP address from a DHCP server.
– Static IP — Uses a static IP address. Specify these IP address properties: IP Address, Subnet Mask,
Default Gateway, DNS Address. If you do not have this information, contact your network administrator.
15