Release Notes

Open Issues and Resolutions
Issue 1
Description
If FlexAddress is enabled on Chassis Management Controllers, iDRAC and Lifecycle Controller does not display the same MAC
addresses.
Resolution
To view the chassis-assigned MAC address, use the iDRAC Web interface or the CMC Web interface.
Versions Affected
All
Issue 2
Description
Windows operating system deployment may intermittently fail with the following error message: "A required CD/DVD drive
device driver is missing. If you have a driver floppy disk, CD, DVD, or USB flash drive, please insert it now."
Resolution
Reboot to Lifecycle Controller and retry until the operating system is successfully deployed.
Versions Affected
Lifecycle Controller 2 Release 1.1
Issue 3
Description
While deploying Windows 2008 R2 SP1 from Lifecycle Controller GUI > OS Deployment, installation terminates with the
following error:
There is no disk in the drive. Please insert a disk into drive
\Device\Harddisk0\DR0.
This issue may occur due to any of the following reasons:
 Virtual Media is in the attached state with no media mapped.
 Virtual Media is in the auto attached state with media mapped.
 Virtual Media being presented by the AVCT SIP and Virtual Media from iDRAC7 in the detached state.
 The underlying cause may be due to failure to load drivers for RAID controllers on the system.
NOTE: It does not occur with Virtual Media in the detached state. It also does not occur without the SIP and with
Virtual Media in the detached from iDRAC7.
Resolution
Retry the operation.
Versions Affected
Lifecycle Controller 2 Release 1.0