White Papers

ManualsBrandsDell ManualsSoftwareLifecycle Controller 2 Release 1.1 Remote Services

201

202

203

204

205

206

207

208

209

210

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Windows Version: 2.1.0

205

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>NIC.1#VLanEnable</p:AttributeName>

<p:AttributeValue>Disabled</p:AttributeValue>

<p:AttributeName>VirtualMedia.1#Attached</p:AttributeName>

<p:AttributeValue>Dettached</p:AttributeValue>

<p:AttributeName>IPv4.1#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>IPv4.1#DHCPEnable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>IPv4.1#DNSFromDHCP</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.3#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

…

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.16#Enable</p:AttributeName>

<p:AttributeValue>Enabled</p:AttributeValue>

<p:AttributeName>Users.3#IpmiLanPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

…

<p:AttributeName>Users.16#IpmiLanPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

<p:AttributeName>Users.3#IpmiSerialPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

…

<p:AttributeName>Users.16#IpmiSerialPrivilege</p:AttributeName>

<p:AttributeValue>Administrator</p:AttributeValue>

</p:ApplyAttributes_INPUT>

OUTPUT:

ApplyAttributes_OUTPUT

Job

Address = http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anonymous

ReferenceParameters

ResourceURI = http://schemas.dell.com/wbem/wscim/1/cim-schema/2/DCIM_LifecycleJob

SelectorSet

Selector: InstanceID = JID_001293705757, __cimnamespace = root/dcim

ReturnValue = 4096

19.4.2 Polling Job Completion

Use the Get() command to check the progress of the ApplyAttributes() method. It polls for job

completion. This method takes the InstanceID from the previous section (19.3.1) as input. The

JobStatus value is either “Successful” or “Failed”. If the job failed, the Message value contains more

detailed error information on the cause of the failure.

Run the Get() command on DCIM_LifecycleJob with the following parameters and syntax:

EXAMPLE: