Manualshelf

White Papers

ManualsBrandsDell ManualsSoftwareLifecycle Controller 2 Release 1.1 Remote Services
151152153154155156157158159160
Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0
155
<n1:AttributeName>LegacyBootProto</n1:AttributeName>
<n1:CurrentValue>iSCSI</n1:CurrentValue>
<n1:DefaultValue xsi:nil="true"/>
<n1:FQDD>NIC.Embedded.1-1</n1:FQDD>
<n1:InstanceID>NIC.Embedded.1-1:LegacyBootProto</n1:InstanceID>
<n1:IsReadOnly>false</n1:IsReadOnly>
<n1:PendingValue xsi:nil="true"/>
<n1:PossibleValues>PXE</n1:PossibleValues>
<n1:PossibleValues>iSCSI</n1:PossibleValues>
<n1:PossibleValues>NONE</n1:PossibleValues>
<n1:PossibleValues>PXE</n1:PossibleValues>
<n1:PossibleValues>NONE</n1:PossibleValues>
</n1:DCIM_NICEnumeration>
15.10 Setting the IscsiOffloadMode Attribute
The SetAttribute() method is used to set or change the value of a CNA attribute. Enable the NICMode,
IscsiOffloadMode, and FcoeOffloadMode personality attributes to enable the corresponding
personalities: NIC, ISCSI, and FCOE.
For Broadcom CNA cards, the partitions on each port can be set to any personality. NICMode can always
be enabled or disabled for any of the given partitions. For the IscsiOffloadMode and FcoeOffloadMode
personalities, up to two personalities can be enabled on each port.
For the Qlogic CNA cards, partition three can be set to either NICMode or IscsiOffloadMode. Partition
four can be set to either NICMode or FcoeOffloadMode.
Invoke the SetAttribute() method with the following parameters (from Section 15.1) and syntax:
Target: FQDD attained through DCIM_NICEnumeration
AttributeName: Attained from AttributeName field
AttributeValue: A new value to assign to the specified NICAttribute. If this value is valid, it is
applied to the PendingValue property or the Currentvalue property of the specified
NICAttribute. Possible choices are attained from PossibleValues field, such as:
Possible values: Disabled, Enabled
EXAMPLE:
wsman invoke -a SetAttribute http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService
?SystemCreationClassName=DCIM_ComputerSystem,
CreationClassName=DCIM_NICService,SystemName=DCIM:ComputerSystem,
Name=DCIM:NICService