Owner's Manual

Troubleshooting and Frequently Asked Questions 117
Repairing USC-LCE
If the message System Services update required appears during
power-on self-test (POST), the embedded device that stores USC-LCE may
contain corrupted data.
To resolve the issue, you must first attempt to update
USC - LCE by executing USC-LCE Dell Update Package (DUP). See the
Dell Update Packages User’s Guide available at support.dell.com/manuals
for more information. If running the DUP does not solve the problem,
use USC-LCE repair package:
1 Go to ftp.dell.com  LifecycleController and download the file named
USC_1.4.0_Rep_Pack_A00.usc (or newer version) to a temporary location.
2 Connect to iDRAC on your system using the iDRAC Web interface.
For
more information on iDRAC, see the Integrated Dell Remote Access
Controller 6 (iDRAC6) User’s Guide
.
3 From the iDRAC Web interface, click Remote Access .
4 Select the Update tab, and then browse to USC-LCE Repair Package you
downloaded from
ftp.dell.com .
5 Click Next , and then click OK to confirm the upload. Allow the process to
complete before you continue to
step 6.
6 Reboot your system, and then press the <F10> key to enter USC-LCE.
7 Complete the installation of all recommended updates. See Updating
Platform for more information. When updates are complete, your system
automatically reboots.
8 While the system reboots, press the <F10> key again to enter
USC - LCE .
If a warning message appears on the initial USC-LCE screen, you must
repeat
step 7 until the server is in a fully-recovered state.
NOTE: Updates that are required for a complete system recovery are pre-
selected by USC-LCE. It is highly recommended that you run all the selected
updates on the system.
USC_USC-LCE.book Page 117 Monday, June 30, 2014 2:56 PM