Users Guide

Use Case Scenarios 97
• To set iSCSI first target, set appropriate values to each for the following:
– IscsiInitiatorIpAddr
– IscsiInitiatorSubnet
– IscsiInitiatorSubnetPrefix
– IscsiInitiatorGateway
– IscsiInitiatorPrimDns
– IscsiInitiatorSecDns
– IscsiInitiatorName
– IscsiInitiatorChapId
– IscsiInitiatorChapPwd
• To configure FCoE boot target, set appropriate values for each of the
following:
–MTUParams
–ConnectFirstFCoETarget
– FirstFCoEWWPNTarget
– FirstFCoEBootTargetLUN
– FirstFCoEFCFVLANID
Getting and Setting the iDRAC Attributes
Using Remote Services, you can set the iDRAC attributes listed in the
following tables:
Table 5-9. LAN Attributes
Attribute Description Values
VLAN
Enabled
The VLAN mode of operation and parameters. When
VLAN is enabled, only matched VLAN ID traffic is
accepted. When disabled, VLAN ID and VLAN Priority
are not available, and any values present for those
parameters are ignored.
Enable or
Disable
VLAN ID Sets the VLAN ID value. Legal values are defined by IEEE
801.11g specification.
1 to 4094