Users Guide

94 Use Case Scenarios

Invoke the

CreateTargetedConfigJob()

method to apply the pending

values. If this method is successful, the system must return a job ID for the

configuration task you created.

NOTE: The system must reboot to execute the task of setting the attribute or

attributes.

Create a reboot job with

CreateRebootJob()

and schedule all the partition

jobs and the reboot job using

SetupJobQueue()

. Pending changes on the

partitions are lost if they are not scheduled to run together.

You can query the status of the jobID output using the job control profile

methods.

Repeat step 4 to confirm successful execution of the method.

References

NOTE: The sections referenced in this table contain only generic examples.

Table 5-7. Step Number and Location

Step Number Location in Lifecycle Controller Web Services Interface Guide

(Windows or Linux)

step 1

15.1 — Listing the CNA Inventory-Enumeration Class

step 2

15.8 — Setting CNA LAN Modes

step 4

15.3 — Listing CNA Inventory-Integer Class

step 5

15.9 — Setting the MaxBandwidth Attribute

step 6

15.3 — Listing CNA Inventory-Integer Class

step 7

15.5 — Applying the Pending Values for CNA-

CreateTargetedConfigJob()

step 8

15.5 — Applying the Pending Values for CNA-

CreateTargetedConfigJob()

step 9

15.5 — Applying the Pending Values for CNA-

CreateTargetedConfigJob()

step 10

10.2.3 — List Jobs in Job Store

Profiles

Simple NIC Profile document at delltechcenter.com/page/DCIM.Library