Users Guide

Use Case Scenarios 93

NOTE: On a partition, as multiple personalities are supported, you can either

enable or disable multiple personalities at the same time. For limitations on

the setting the personalities on different CNA cards, see the Release Notes or

the Simple NIC Profile document at delltechcenter.com/page/DCIM.Library.

Go to step 6 to complete the remaining steps.

Changing the Bandwidth

Enumerate the DCIM_NICInteger class and identify the current value of

the instances of the class with AttributeName=MaxBandwidth or

MinBandwidth and their FQDD properties. See

Ta b l e 5-6 for the

maximum and minimum bandwidth values.

NOTE: For limitations on the setting the bandwidth on different CNA cards,

see the Release Notes or the Simple NIC Profile document at

delltechcenter.com/page/DCIM.Library.

For the identified partition, use the FQDD and invoke the

SetAttribute()

method to change the bandwidth.

Check the updated value in the pending field of the attribute.

Before invoking the

CreateTargetedConfigJob()

method, construct the

input parameters (Target,

RebootJobType

ScheduledStartTime

UntilTime

, and so on).

If more than one partition on a port has a configuration change, do not

specify

RebootJobType

and

ScheduledStartTime

. Schedule the

job using the job control profile methods. Go to

step 9 to create the jobs.

NOTE: See the Simple NIC Profile document at

delltechcenter.com/page/DCIM.Library to see the list of all the supported

input parameters.

Table 5-6. Bandwidth

Minimum Maximum

20 30

30 40

25 35