Release Notes

Issue 5
Description
You may see a no optical device found error if you have a bad DVD/CD in the optical drive. This error does
not mean that there are no optical devices on the system. If you remove the bad media, then this error is
resolved.
Issue 6
Description
For RedHat Enterprise Linux version 4.8 operating system, you may need to install kernel source before
installing the drivers present in OEMDRV.
Issue 7
Description
For RAID Configuration, PERC 6.1 Firmware or above is required.
Issue 8
Description
If a floppy drive is attached to the system when the USC is used to deploy a Windows 2003 Server
operating system, error pop-up messages is displayed, and many required device drivers such as NIC, video,
and chipset drivers are not installed, but the storage device drivers is installed. Do not attach floppy devices
before using the USC to deploy a Windows 2003 Server operating system.
Issue 9
Description
If you see this error message "Unable to find a boot device on which to install the operating system. Verify
boot disk availability." and if you have a USB key plugged in to the system after booting to USC, remove the
USB key before deploying the operating system.
Issue 10
Description
Note: Account access can be disabled only if there is more than one user enabled on the iDRAC. To enable
users, access the iDRAC Web-based GUI. Navigate to the Users section under the Network/Security tab and
enable users as needed. Note that at least one more user needs to be enabled in order to disable the
account access in the USC.
Issue 11
Description
During an UEFI based SLES 10 and SLES 11 installation, ensure that no additional USB or block storage
devices are connected to the system. If there are one or more USB or block storage devices plugged into
the system, the auto loading of drivers from the embedded storage fails. This fails because the current
implementation of SLES installer reads only from one USB or block storage device.
Issue 12
Description
SAS controllers do not support virtual disk slicing.