Release Notes
Table Of Contents
- Dell Lifecycle Controller USC-LCE Version 1.5.5 Readme
- What’s New?
- Prerequisites for using USC-LCE
- Supported Dell Systems and Operating Sys
- Installation and Configuration
- Open Issues, Limitations, and Resolution
- Issue 1
- Issue 2
- Issue 3
- Issue 4
- Issue 5
- Issue 6
- Issue 7
- Issue 8
- Issue 9
- Issue 10
- Issue 11
- Issue 12
- Issue 13
- Issue 14
- Issue 15
- Issue 16
- Issue 17
- Issue 18
- Issue 19
- Issue 20
- Issue 21
- Issue 22
- Issue 23
- Issue 24
- Issue 25
- Issue 26
- Issue 27
- Issue 28
- Issue 29
- Issue 30
- Issue 31
- Issue 32
- Issue 33
- Issue 34
- Issue 35
- Global Support
Issue 35
Description
While deploying Windows 2008 R2 SP1 or Windows SBS 2011 operating system using USC-LCE, the
installation terminates with the error: There is no disk in the drive. Please insert a disk into drive
\Device\Harddisk0\DR0 or DR1. This issue occurs because the drivers for the RAID controllers are not
loaded due to any of the following reasons:
Virtual Media is in the attached state with no media mapped.
Virtual Media is in the auto-attached state with media mapped.
Virtual Media is in the detached state.
To resolve this issue, retry the operation.
Global Support
For information on technical support, visit
dell.com/contactus
.
For information on documentation support, visit
support.dell.com/manuals
. On the
Manuals
page, click
Software
→
Systems Management
. Click on the right‐side, and select the product to access the documents
.