Users Guide

88 Troubleshooting and Frequently Asked Questions
RAID configuration
failed
USC-LCE failed when creating the RAID configuration.
To resolve this issue:
1 Reboot the system.
2 Re-enter USC-LCE by pressing the <F10> key.
3 Try again to create the RAID configuration.
Generic Failure USC-LCE experienced an unidentified error when creating
the RAID configuration. To resolve this issue:
1 Reboot the system.
2 Re-enter USC-LCE by pressing the <F10> key.
3 Try again to create the RAID configuration.
Sufficient physical disks
not available on any
supported RAID
controller. The wizard
will exit.
You do not have a sufficient number of disks to support
RAID configuration—you must attach more physical disks
and start the RAID Configuration wizard again.
Please select required
number of physical
disk(s) for current span
The number of physical disks you selected for the current
RAID span is incorrect. Review your span selections,
and enter the correct number.
No physical disk has
been selected for this
virtual disk
The number of physical disks you selected for the virtual
disk is insufficient. Review the minimum number of
physical disks required for the current RAID level, and select
at least that number of physical disks.
No controller is present
in the system
No RAID controller is present in your system. To resolve
this
issue:
1 Add a supported RAID controller that includes two or more
physical disks.
2 Re-enter USC-LCE by pressing the <F10> key.
3 Restart the RAID Configuration wizard.
No valid RAID level
found
The number of physical disks attached to your system is
insufficient for the RAID level you selected. Attach more
physical disks and try again.
Table A-3. USC-LCE Error Messages and Resolutions (continued)
Error Message Resolution
LC1_4.book Page 88 Friday, October 22, 2010 2:45 AM