Users Guide

USC and USC - LCE 71

•

Password

— Type the correct password.

• File Location — Type the sub-directories if any. For example,

2010\Apr

For NFS

•

Share Name

—

Type the path to the shared folder where you must

store the file. For example, type

\\xxx.xxx.xx.xx\HrdInvLog

•File Location —

Type the sub-directories if any. For example,

2010\Apr

Click

Test Network Connection

to verify if USC-LCE is able to connect to

the IP address that you provided. By default, it pings the Gateway and

DNS server IP.

Click

Viewing and Exporting Hardware Inventory after Resetting Lifecycle

Controller

To view or export the correct hardware inventory data after resetting the

Lifecycle Controller:

NOTE: After performing Delete Configuration and Reset Defaults, the system shuts

down.

Power on the system and wait for a couple of minutes for iDRAC to start

functioning.

Since Collect System Inventory on Restart (CSIOR) is not enabled upon

reset, press <F10> to launch USC so that the system inventory is

collected. After USC launches, exit the wizard and wait for the system to

reboot.

Disconnect the power cord and wait for 30 seconds. Reconnect the power

cord and boot the system to USC.

LC1_4.book Page 71 Friday, October 22, 2010 2:45 AM