Users Guide

64 USC and USC - LCE
vFlash SD Card Configuration
Use this feature to enable or disable the vFlash SD card, check the health and
properties, and initialize the vFlash SD card. The Dell vFlash SD card enables
the part replacement feature. USC-LCE support vFlash SD cards of sizes 1
GB, 2 GB, or 8 GB.
NOTE: The options under vFlash SD card are grayed-out if there is no SD card
inserted in the slot.
See the Integrated Dell Remote Access Controller 6 (iDRAC6) User’s Guide
available at support.dell.com/manuals for more information on vFlash SD
card and the installation procedure.
Use the vFlash SD Card Configuration to:
• Enable/disable vFlash SD card.
• Determine the vFlash SD card properties:
–Name
–Health
– Size - Indicates the total size of the vFlash SD card.
– Available Space - Indicates the available size on the vFlash SD card to
create a new partition.
– Type - Indicates the type of card, SD (Secure Digital) or MMC
(MultiMediaCard).
– Write Protected - Indicates if the write-protect latch on the vFlash SD
card is set to on or off position.
• Initialize vFlash - This deletes all the existing partitions on vFlash SD
card.
NOTE: You can only use 256 MB of memory space in non-Dell SD cards.
Table 4-1. Health Status and Response Action
Health State Response Action
OK None
Warning Initialize and try again
Critical Remove, reset, and try again
Initialize and try again
LC1_4.book Page 64 Friday, October 22, 2010 2:45 AM