Users Guide

54 USC and USC - LCE
Confirmation
Confirm the changes you made by viewing the Summary screen. You can
apply the changes, or cancel all changes and exit the iDRAC Configuration
Wizard. If you apply the changes, a Please Wait message displays while
your changes are saved. When the operation is complete, a final
Confirmation screen displays indicating whether the changes were applied
successfully, left unchanged, or failed.
Click Finish to save your settings and return to the main wizards screen.
RAID Configuration
If your system has one or more supported PERC RAID controller(s) with
PERC 6.1 firmware or greater or SAS RAID controller(s), you have the
option of using the RAID Configuration wizard to configure a virtual disk
as the boot device.
Important
• For S100 /S300 controllers, virtual disks cannot be created using the
RAID Configuration Wizard in USC-LCE. To create RAID, use the
controller utilities
by pressing <Ctrl><R> when prompted during
system start-up.
• USC can display only three storage controllers for RAID configuration on
the console.
• If there are any internal storage controller cards on the system, all other
external cards cannot be configured. If there are no internal cards present,
then external cards can be configured.
To launch the RAID Configuration Wizard:
1 Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click RAID Configuration to launch the wizard.
The following steps will walk you through the RAID Configuration
wizard:
a "View Current Configuration" on page 55
b "Select RAID Controller" on page 55
c "Foreign Configuration Found" on page 55
LC1_4.book Page 54 Friday, October 22, 2010 2:45 AM