Users Guide

USC and USC - LCE 45
iDRAC Configuration
Use the iDRAC Configuration Wizard to configure and manage
iDRAC parameters.
This wizard is similar to the iDRAC Configuration Utility in the legacy
BIOS operation. You can use the wizard to configure iDRAC parameters
applicable to the system, such as LAN, common IP settings, IPv4, IPv6,
virtual media, and LAN user configuration.
To launch the iDRAC Configuration Wizard:
1 Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click iDRAC Configuration to launch the wizard.
The following steps walks you through the iDRAC Configuration Wizard:
a "LAN Configuration" on page 45
b "Advanced LAN Configuration" on page 47
c "Common IP Configuration" on page 48
d "IPv4 Configuration" on page 48
e "IPv6 Configuration" on page 50
f "Virtual Media Configuration" on page 51
g "LAN User Configuration" on page 52
h "Confirmation" on page 54
LAN Configuration
View or configure iDRAC LAN, IPMI over LAN, MAC address,
and NIC selection.
• iDRAC LAN — Enables or disables the iDRAC NIC. Disabling
iDRAC
LAN deactivates the remaining controls.
• IPMI Over LAN — Enables or disables Intelligent Platform
Management
Interface (IPMI) commands on the iDRAC
Local
Area Network (LAN) channel.
• MAC Address — Enables you to view the Media Access Control (MAC)
address that uniquely identifies each node in a network (read-only).
LC1_4.book Page 45 Friday, October 22, 2010 2:45 AM