User's Manual

Troubleshooting 73
Invalid value for
ExposeDuration - must
be 60-65535 seconds
The value specified for ExposeDuration is out of range.
It must be 60-65535 seconds
Run the command again with ExposeDuration
value 60 to 65535 seconds.
Copying operating
system drivers to
network share failed
The share may be read-only or the driver pack present in
Lifecycle Controller may be corrupt.
Ensure that the network share has write permission, or
update the Driver Pack either remotely using WS-
Management or locally using USC or DUP and then run
the command again.
Unable to detach ISO
image from the system
Cannot continue with DetachISOImage because system
does not have attached ISO image.
Do not run DetachISOImage command.
Installed BIOS version
does not support this
method.
The system has an older version of BIOS that does not
support this method. Install the latest version of BIOS to
use this method.
Update the BIOS to version 1.2 or later and then run the
command again.
Unable to continue with
BootToPXE - ISO image
is attached to the
system.
Unable to continue with BootToPXE command because
system has an ISO image attached. Detach the ISO image
before continuing with BootToPXE.
Run DetachISOImage command and then run
BootToPXE.
Lifecycle Controller is
disabled
Lifecycle Controller is disabled on the system, so none of
the remote enablement OSD commands will work.
Ensure Lifecycle Controller is enabled before running
any command
Reboot the system and enable System Services using
CTLR+E option in the POST
Table 5-1. Lifecycle Controller - Remote Services Error Messages and Resolutions
Error Message Resolution
RemoteServices1_4.book Page 73 Thursday, October 21, 2010 5:05 PM