User's Manual

72 Troubleshooting
Unable to continue
with DetachISOImage -
another command is in
the process of exposing
ISO Image and
booting to it.
Cannot continue with DetachISOImage because another
command is in the process of exposing ISO image and
booting to it.
See ConcreteJob status to ensure that the current running
process is complete and then run DetachISOImage.
Unable to continue
with DetachDrivers -
UnPackAndAttach
is in progress
Wait until UnpackAndAttach finishes and then run
DetachDrivers.
Unable to detach
USB device containing
operating system drivers.
Detaching the USB device (that contains drivers for the
operating system installation) from the host has failed.
The device may have been detached already or
IDRAC may not be operating normally.
Reset iDRAC to detach this device automatically.
Unable to continue with
BootToPXE - another
command is running.
Unable to continue with BootToPXE command because
another process is using Lifecycle Controller.
See ConcreteJob status to ensure that the current running
process is complete and then run BootToPXE.
Copying drivers for
selected operating
system failed.
Copying drivers for selected operating system failed.
The Driver Pack may be corrupt.
Update the Driver Pack either remotely using WS-
Management or locally using USC or DUP and then run
the command again.
Hash verification on
the ISO image failed.
Hash verification on the ISO image has failed. The hash
value specified in the command is either not correct or the
ISO image has been changed.
1 Verify that the hash value specified in the command is
correct.
2 Ensure that the ISO has not been changed - replace the
ISO image on the share and run the command again.
Driver Pack config file
not found in Lifecycle
Controller. Driver Pack
might be corrupt.
Update the Driver Pack either remotely using WS-
Management or locally
using USC or DUP and then run the
command again.
Table 5-1. Lifecycle Controller - Remote Services Error Messages and Resolutions
Error Message Resolution
RemoteServices1_4.book Page 72 Thursday, October 21, 2010 5:05 PM