User's Manual

Remote Services Operations 23
• Auto-Discovery feature does not use the newly set provisioning server IP
address/hostname for any handshakes in progress, but is used only during
the next handshake process.
• Auto-Discovery feature supports setting multiple IP addresses and/or
hostnames using the following format:
• The string is a list of IP addresses and/or hostnames and ports
separated by comma.
• Hostname can be fully qualified.
• IPv4 address – starts with ‘(‘ and ends with ‘)’ when specified at the
same time with a hostname.
• Each IP address or hostname can be optionally followed by a ‘:’ and a
port number.
• Examples of valid strings are - hostname, hostname.domain.com.
Setting Provisioning Server using the USC Console
1 Press <F10> System Services when prompted within 5 seconds during
system startup.
The
Unified Server Configurator Lifecycle Controller Enabled screen
appears.
2 Navigate to Hardware Configuration -> Configuration Wizard ->
iDRAC6 Configuration .
3 Use the Next button to navigate to the LAN User Configuration screen.
4 Navigate to the Provisioning Server Addresses screen.
5 Enter the IP/hostname string of the Provisioning Server host.
6 Click Next and then click Apply .
7 Click Finish .
8 Click Exit and Reboot . Confirm exit.
Set Provisioning Server using iDRAC6 Configuration Utility
1 Press <Ctrl+e> when prompted within 5 seconds during system start-up.
The
iDRAC6 Configuration Utility screen appears.
RemoteServices1_4.book Page 23 Thursday, October 21, 2010 5:05 PM