User's Manual

Troubleshooting and Frequently Asked Questions 101
Cannot access Driver
Pack partition in
Lifecycle Controller.
Driver Pack partition in Lifecycle Controller is not
accessible. The Lifecycle Controller might be corrupted.
1 Reset iDRAC and run the command.
Driver Pack not found in
Lifecycle Controller
No Driver Pack in Lifecycle Controller.
1 Update the Driver Pack using USC or DUP and then run
the command again.
Cannot allocate memory Unable to dynamically allocate memory to
perform the task.
1 Reset iDRAC and run the command.
Driver Pack does not
have drivers for the
selected operating
system.
Lifecycle Controller does not have any drivers for the
selected operating system. The installation will have to use
the native drivers present on the operating system media.
Cannot create
USB device to copy
drivers for the selected
operating system.
Unable to create USB device to copy drivers for selected
operating system. iDRAC may not be operating normally
1 Reset iDRAC and run the command again.
Cannot mount
USB device to copy
drivers for the selected
operating system.
Unable to access the newly created USB device to copy
drivers for selected operating system. IDRAC may not be
operating normally
1 Reset iDRAC and run the command again
Unable to expose
USB device containing
operating system drivers
to host system.
Unable to expose the newly created USB device (with
drivers for selected operating system) to the host server.
IDRAC may not be operating normally.
1 Reset iDRAC and run the command again.
Mount network share
failed - incorrect
username or password.
Unable to mount the network share using the credentials
specified in the command. Either username or password
is incorrect.
1 Run the command again with correct username and
password.
Table A-4. Lifecycle Controller Error Messages and Resolutions (continued)
Error Message Resolution
LC1_3.book Page 101 Monday, December 7, 2009 3:14 PM