User's Manual

96 Troubleshooting and Frequently Asked Questions
Table A-3. USC - LCE Error Messages and Resolutions
Error Message Resolution
Drivers pack not found
OR
Error populating OS list
USC - LCE cannot find the drivers required to install the
operating system. To resolve this issue, perform a platform
update (see "Updating the Platform using the Platform
Update Wizard.)"
Unable to find a device
capable of reading the
OS install media
USC - LCE cannot detect a device to read the operating
system media. One of the following situations is probably
causing the error:
• No optical device is available on the system. Shut down
the system and add a SATA optical device or
USB optical device.
• If an optical device is present, it may not be properly
connected. Check to ensure the device cables are
adequately seated.
• If an optical device is present, it is disabled in the BIOS.
Reboot the system, enter the BIOS setup utility, and enable
the SATA ports for the optical device.
• iDRAC virtual media is disabled. See the
Integrated
Dell Remote Access Controller 6 (iDRAC6) User’s Guide
for your system available at support.dell.com/manuals .
The repository you
selected as a source for
the updates has failed
an integrity check
This error may be caused by temporary network problems;
try again later to connect to the update repository. If you are
using a local USB device for your update repository and this
problem persists, create the repository again (see
"Configuring a Local USB Device") or provide an alternate
repository.
Decompression of the
catalog file failed
The catalog downloaded to compare currently installed
versions with the latest available versions cannot be
decompressed. This error may be caused by temporary
network problems; try again later to connect to the update
repository. If you are using a local USB device for your
update repository and this problem persists, create the
repository again (see "Configuring a Local USB Device")
or provide an alternate repository.
LC1_3.book Page 96 Monday, December 7, 2009 3:14 PM