User's Manual

Remote Service Features 71
• Each IP address or hostname can be optionally followed by a ‘:’ and a
port number.
• Examples of valid strings are - hostname, hostname.domain.com
Setting Provisioning Server using the USC Console
1 Press <F10> System Services when prompted within 5 seconds during
system start-up.
The
Unified Server Configurator Lifecycle Controller Enabled page
displays.
2 Navigate to Hardware Configuration -> Configuration Wizard ->
iDRAC6 Configuration .
3 Use the Next button to navigate to LAN User Configuration .
4 Navigate to Provisioning Server Addresses .
5 Enter the IP/hostname string of the Provisioning Server host.
6 Click Next and then click Apply .
7 Click Finish .
8 Click Exit and Reboot . Confirm exit.
Set Provisioning Server using iDRAC6 Configuration Utility
1 Press <Ctrl+e> when prompted within 5 seconds during system start-up.
2 The iDRAC6 Configuration Utility page displays.
3 Navigate to LAN User Configuration .
4 Select Provisioning Server .
5 Enter the IP/hostname string of the Provisioning Server host.
6 Click Enter .
7 Save and Exit the iDRAC6 Configuration Utility.
Remotely Reinitiating Auto-Discovery in New Environments
This feature allows you to reinitiate Auto-Discovery through WS-MAN, even
though Auto-Discovery has taken place earlier. It can be used when you need
to move a server from one data center to another. The Auto-Discovery
settings will be persisted using the existing user credentials.
LC1_3.book Page 71 Monday, December 7, 2009 3:14 PM