User's Manual

56 USC and USC - LCE
• Select the physical disk to be used as the hot spare from the Hot Spare
Disk
drop-down menu.A hot spare can be used only with a redundant
RAID level. Hot spares also have requirements for physical disk size. The
hot spare cannot be smaller than the smallest physical disk included in the
virtual disk. If the RAID level and physical disk availability do not meet
these requirements, the
Assign a Hot Spare Disk check box is disabled.
Click Next after making your selection.
Advanced Wizard Only - Review Summary
The Summary screen displays the virtual disk attributes based on your selections.
CAUTION: Clicking the Finish button deletes all existing virtual disks except for
any foreign configurations that you specified should be kept. All data residing on
the deleted virtual disks will be lost.
Click Finish to create a virtual disk with the displayed attributes.
OR
To return to a previous screen to review or change selections, click Back. To
exit the Wizard without making changes, click Cancel.
Advanced Configuration
Use Advanced Configuration to modify advanced settings.
1
Select Hardware Configuration from the left menu
2 Click Advanced Configuration in the right panel.
3 Select the device you want to configure.
Depending on the configuration setting changes, the following message may
be displayed: One or more of the settings requires a reboot to be saved and
activated. Do you want to reboot now?. You can select No and continue
making additional configuration changes or perform other tasks such as
operating system deployment. All changes will be applied during the next
system boot.
USC - LCE Hardware Configuration allows you to configure other devices
through Human Interface Infrastructure (HII). HII is a UEFI-standard
method for viewing and setting a device's configuration. You can utilize a
single utility to configure multiple devices that had different pre-boot
LC1_3.book Page 56 Monday, December 7, 2009 3:14 PM