User's Manual

50 USC and USC - LCE
The following steps will walk you through the RAID Configuration wizard:
a "View Current Configuration"
b "Select RAID Controller"
c "Foreign Configuration Found"
d "Select the Express or Advanced Wizard"
e "Select Basic Settings"
f "Express Wizard Only - Assign a Hot Spare"
g "Express Wizard Only - Review Summary"
h "Advanced Wizard Only - Select Physical Disks"
i "Advanced Wizard Only - Additional Settings"
j "Advanced Wizard Only - Review Summary"
View Current Configuration
The View Current Configuration screen displays the attributes of
any virtual disks already configured on the supported RAID controllers
attached to the system. You have two options:
• Accept the existing virtual disks without making changes. To select this
option, click
Back . If you intend to install the operating system on an
existing virtual disk, ensure that the virtual disk size and RAID level are
appropriate.
• Delete all existing virtual disks and use the
RAID configuration wizard
to create a single, new virtual disk to be used as the new boot device.
To select this option, click
Next .
NOTE: RAID 0 does not provide data redundancy. Other RAID levels provide
data redundancy and may enable you to reconstruct data in the event of a
disk failure.
Select RAID Controller
The Select RAID Controller screen displays all supported RAID controllers
attached to the system. Select the RAID controller on which you want to
create the virtual disk, and then click Next.
LC1_3.book Page 50 Monday, December 7, 2009 3:14 PM