User's Manual

USC and USC - LCE 49
– Enabled — Enabling Smart Card login disables all command-line
out-of-band interfaces including SSM, Telnet, Serial,
remote RACADM, and IPMI over LAN.
–
Disabled — On subsequent logins from the graphical user interface
(GUI), the regular login page displays. All command-line out-of-band
interfaces—including Secure Shell (SSH), Telnet, Serial, and
RACADM—are set to their default states.
–
Enabled with RACADM — Enabling smart card login with
RACADM disables all command-line out-of-band interfaces—
including SSM, Telnet, Serial, remote RACADM, and IPMI over
LAN—while still allowing RACADM access.
Click
Next to proceed to "Summary."
Summary
Displays the summary of the iDRAC configuration changes.
Click Apply to proceed to "Confirmation."
Confirmation
Confirm the changes you made by viewing the Summary screen. You can
apply the changes, or cancel all changes and exit the iDRAC Configuration
Wizard. If you apply the changes, a Please Wait message displays while
your changes are saved. When the operation is complete, a final
Confirmation screen displays indicating whether the changes were applied
successfully, left unchanged, or failed.
Click Finish to save your settings and return to the main wizards screen.
RAID Configuration
If your system has one or more supported PERC RAID controller(s) with
PERC 6.1 firmware or greater or SAS RAID controller(s), you have the
option of using the RAID Configuration wizard to configure a virtual disk
as the boot device.
To launch the RAID Configuration Wizard:
1
Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click RAID Configuration to launch the wizard.
LC1_3.book Page 49 Monday, December 7, 2009 3:14 PM