User's Manual

48 USC and USC - LCE
• A list of IP addresses and/or hostnames and ports separated by comma.
• Hostname can be fully qualified.
• IPv4 address – starts with ‘(‘ and ends with ‘)’ when specified at the
same time with a hostname.
• Each IP address or hostname can be optionally followed by a ‘:’ and a
port number.
• Example of valid strings are - hostname, hostname.domain.com
•
Account Access — Enables or disables account access. Disabling account
access deactivates all other fields on the
LAN User Configuration screen.
•
Account Username — Enables the modification of an iDRAC username.
The
Account Username field accepts a maximum of 16 printable
ASCII characters.
•
Password — Enables an administrator to specify or edit the iDRAC user's
password. The
Password string is encrypted and cannot be seen or
displayed after this property is set. The
Password field accepts a maximum
of 20 characters.
•
Confirm Password — Re-enter the iDRAC user's password to confirm.
•
Account Privilege — Assigns the user's maximum privilege on the IPMI
LAN channel to one of the following user groups: Admin, Operator, User,
or No Access.
–
Admin — Privileges: Login to iDRAC, Configure iDRAC, Configure
Users, Clear Logs, Execute Server Control Commands, Access
Console Redirection, Access Virtual Media, Test Alerts, Execute
Diagnostic Commands
–
Operator — Privileges: Login to iDRAC, Configure iDRAC,
Configure Users, Execute Server Control Commands, Access Console
Redirection, Access Virtual Media, Test Alerts, Execute Diagnostic
Commands
–
User — Privileges: Login to iDRAC
–
No Access — No assigned privileges
•
Smart Card Authentication — Enables or disables Smart Card
Authentication for iDRAC log in. If enabled, a Smart Card must be
installed to access the iDRAC.
LC1_3.book Page 48 Monday, December 7, 2009 3:14 PM