User's Manual

USC and USC - LCE 47
media devices. If set to Auto-Attach , the virtual media device is
automatically mapped to the server every time the user physically
connects a media.
• vFlash Status — Displays the status as either:
• Formatted
• Not formatted
• Not present
• Not licensed (the vFlash is not Dell-licensed)
For more information on supported virtual media devices, see the Integrated
Dell Remote Access Controller 6 (iDRAC6) User’s Guide available at
support.dell.com/manuals.
• vFlash — Enable or disable the use of flash memory that resides in the
iDRAC file system. This memory can be used for persistent storage and
accessed by the system. If set to
Enabled , the virtual flash card is
configured as a virtual drive; it appears in the boot order, allowing you
to boot from the virtual flash card. If set to
Disabled , virtual flash is
not accessible.
Prerequisites to Enable or Disable vFlash
• To boot from the virtual flash, the virtual flash image must be bootable.
The virtual flash feature of iDRAC requires a formatted secure digital
(SD) card that is 256 MB or greater. This feature can be enabled only if a
valid image is present on the SD card. See the
User Guide for your
system’s iDRAC device for more information.
• Dell-branded vFlash media is required for the virtual flash partition.
Click Next to proceed to "LAN User Configuration."
LAN User Configuration
Set account access, account-related attributes, and smart card authentication
using one of the following methods:
• Auto-Discovery - Enables or disables auto-discovery.
• Provisioning Server Address - Enables you to enter the Provisioning Server
address; valid address formats are IPv4, IPv6, or the provisioning server
hostname.
Provisioning Server address criteria are:
LC1_3.book Page 47 Monday, December 7, 2009 3:14 PM