User's Manual

22 USC and USC - LCE
3 Click Next .
If your system has a RAID controller, continue with "Optional RAID
Configuration." If your system does not have a RAID controller, continue
with "Select an Operating System."
Optional RAID Configuration
If your system has a RAID controller, you have the option of launching the
RAID Configuration wizard and configuring a virtual disk as the boot device.
To configure RAID:
• Select Configure RAID Now and click Next . This option launches
the
RAID Configuration wizard. After RAID configuration is complete,
you will return to the
OS Deployment wizard. See "Configuring RAID."
To bypass RAID configuration:
• Select
Go Directly to OS Deployment and click Next . This option
launches the
OS Deployment wizard. If you select this option,
the operating system will be installed on the default boot device identified
in the BIOS utility. Continue with
"Select an Operating System."
Deploy the Operating System
The drivers required by the operating system, or recommended for updating
your system after installation, are extracted to a temporary location.
These files are deleted after an 18-hour period or when you press
the <F10> key to either cancel operating system installation or re-enter
USC after rebooting.
NOTE: During the 18-hour period when drivers are extracted to a temporary
location after the operating system is installed, you cannot update USC or USC-LCE,
drivers, or hardware diagnostics using a DUP. If you attempt an update using a DUP
during this time period, the DUP will display a message that another session is
open.
Select an Operating System
Use the following steps to select an operating system:
1
Select the operating system you want to install and click Next .
LC1_3.book Page 22 Monday, December 7, 2009 3:14 PM