User's Manual

18 USC and USC - LCE
CAUTION: This action cancels all tasks USC or USC - LCE is in the process of
executing. Dell strongly recommends that you cancel the request to enter System
Services only when absolutely necessary.
1 Press <Ctrl><e> within 5 seconds when prompted during system
start-up.
The iDRAC6 Configuration Utility page displays.
2 Navigate to System Services .
3 Select Cancel System Services .
Save your changes and exit the
iDRAC6 Configuration Utility page.
The system reboots automatically.
Using USC Settings Wizard
USC Settings wizard enables you to specify the language, keyboard layout,
and network settings for USC or USC - LCE. USC settings apply only to USC
or USC - LCE and do not apply to the system or any other application
running on the system.
1
Launch USC Settings Wizard:
a Boot your system and press the <F10> key within 10 seconds of the
Dell logo being displayed.
b Wait until USC Home screen is displayed, then click USC Settings in
the left pane.
2 Click Language and Keyboard in the right pane. Use the up-arrow and
down-arrow keys to access all options on the
Language and Keyboard Type
drop-down menus.
a Select the language from the Language drop-down menu.
b Select the type of keyboard you are using from the Keyboard Type
drop-down menu.
c Click Finish .
3 Click Network Settings in the right pane.
a Use the NIC Card drop-down menu to select the NIC card you want
to configure on your system.
b Use the IP Address Source drop-down menu to select either No
Configuration
, DHCP , or Static IP . The IP Address Source function
only supports IPv4.
LC1_3.book Page 18 Monday, December 7, 2009 3:14 PM