Read me

file:///T|/htdocs/SOFTWARE/smusc/smlc/lc_1_3/en/Readme/readme.txt[10/25/2012 1:39:51 PM]
#########################################################################
CONTENTS
#########################################################################
* Criticality
* Compatibility/Minimum Requirements
* Installation
* Known Issues
#######################################################################
CRITICALITY
#######################################################################
2 = Recommended
#######################################################################
COMPATIBILITY/MINIMUM REQUIREMENTS
#######################################################################
Supported Microsoft(R) Windows(R), Red Hat(R) Enterprise Linux(R),
and SUSE(R) Linux Enterprise Server operating systems. See the
"Dell System Software Support Matrix" on the Dell Support site for
details.
#######################################################################
INSTALLATION
#######################################################################
To start the USC, press the <F10> key within 10 seconds of the Dell
logo being displayed during the system boot process.
NOTE: If you power on or restart the system while iDRAC is
initializing, the message System Services Disabled will display during
the system boot process. This occurs if you power on the system
immediately after AC is applied to the server, or if you restart the
system immediately after resetting the iDRAC. To avoid this issue, wait
about a minute to restart the server. This will allow enough time for
the iDRAC to complete initialization.
The first time you boot the system, the USC starts with the User
Settings wizard displayed so that you can configure your preferred
language and network settings. See "Unified Server Configurator User's
Guide" for more information.
#######################################################################
KNOWN ISSUES
#######################################################################
After you apply newer firmware on H200i storage controller, there will be a delay of 2 to 3
minutes.
The drivers exposed by USC will be present in a read-only device
labeled OEMDRV, and the device will be active for 18 hours. In a