User's Manual

USC and USC - LCE 45
Confirmation
Confirm the changes you made by viewing the Summary screen. You can
apply the changes, or cancel all changes and exit the iDRAC Configuration
Wizard. If you apply the changes, a Please Wait message displays while
your changes are saved. When the operation is complete, a final
Confirmation screen displays indicating whether the changes were applied
successfully, left unchanged, or failed.
Click Finish to save your settings and return to the main wizards screen.
RAID Configuration
If your system has one or more supported PERC RAID controller(s) with
PERC 6.1 firmware or greater or SAS RAID controller(s), you have the
option of using the RAID Configuration wizard to configure a virtual disk
as the boot device.
To launch the RAID Configuration Wizard:
1
Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click RAID Configuration to launch the wizard.
The following steps will walk you through the RAID Configuration wizard:
a "View Current Configuration"
b "Select RAID Controller"
c "Foreign Configuration Found"
d "Select the Express or Advanced Wizard"
e "Select Basic Settings"
f "Express Wizard Only - Assign a Hot Spare"
g "Express Wizard Only - Review Summary"
h "Advanced Wizard Only - Select Physical Disks"
i "Advanced Wizard Only - Additional Settings"
j "Advanced Wizard Only - Review Summary"
LC1_2.book Page 45 Wednesday, November 18, 2009 9:42 AM