User's Manual

USC and USC - LCE 43
• Virtual Flash — Enable or disable the use of flash memory that resides
in the iDRAC file system. This memory can be used for persistent storage
and accessed by the system. If set to
Enabled , the virtual flash card is
configured as a virtual drive; it appears in the boot order, allowing you
to boot from the virtual flash card. If set to
Disabled , virtual flash is
not accessible.
NOTE: To boot from the virtual flash, the virtual flash image must be bootable.
The virtual flash feature of iDRAC requires a formatted secure digital (SD)
card that is 256 MB or greater. This feature can be enabled only if a valid
image is present on the SD card. S
ee the User Guide for your system’s
iDRAC device for more information.
NOTE: Dell-branded vFlash media is required for the virtual flash partition.
Click Next to proceed to "LAN User Configuration."
LAN User Configuration
Set account access, account-related attributes, and smart card authentication.
• Account Access — Enables or disables account access. Disabling account
access deactivates all other fields on the
LAN User Configuration screen.
•
Account Username — Enables the modification of an iDRAC username.
The
Account Username field accepts a maximum of 16 printable
ASCII characters.
•
Password — Enables an administrator to specify or edit the iDRAC user's
password. The
Password string is encrypted and cannot be seen or
displayed after this property is set. The
Password field accepts a maximum
of 20 characters.
•
Confirm Password — Re-enter the iDRAC user's password to confirm.
LC1_2.book Page 43 Wednesday, November 18, 2009 9:42 AM