User's Manual

USC and USC - LCE 35
System Date/Time Configuration
Use the System Date/Time Configuration Wizard to set the date and time
for the system.
To launch the System Date/Time Configuration Wizard:
1
Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click System Date/Time Configuration to launch the wizard.
The default system date and system time shown in USC - LCE is the date
and time reported by the system BIOS.
4 Modify the System Date and Time (HH:MM:SS AM/PM) values,
as required.
5 Click Finish to apply the changes.
To return to the Configuration Wizards screen, click Back.
To exit the wizard, click Cancel.
iDRAC Configuration
Use the iDRAC Configuration Wizard to configure and manage
iDRAC parameters.
This wizard is similar to the iDRAC Configuration Utility in the legacy
BIOS operation. You can use the wizard to configure iDRAC parameters
applicable to the system, such as LAN, common IP settings, IPv4, IPv6,
virtual media, and LAN user configuration.
To launch the iDRAC Configuration Wizard:
1
Click Hardware Configuration in the left pane.
2 Click Configuration Wizards in the right pane.
3 Click iDRAC Configuration to launch the wizard.
The following steps will walk you through the iDRAC Configuration Wizard:
a "LAN Configuration"
b "Advanced LAN Configuration"
c "Common IP Configuration"
d "IPv4 Configuration"
LC1_2.book Page 35 Wednesday, November 18, 2009 9:42 AM