User's Manual

USC and USC - LCE 23

Reboot the System

Use the following steps to reboot the system:

Click

Finish

to reboot the system and continue with the operating system

installation. Upon reboot, the system boots to the operating system

installation media.

CAUTION: During Red Hat 5.x installation, you will receive a warning that a

read-only file system was detected; Linux has detected the temporary storage area

of USC and USC-LCE that stores updates for your system. Click OK, and a second

warning will appear indicating that the read-only file system has a loop partition

layout and that it needs to be formatted. Click the Ignore drive button. You may see

both warnings several times during the course of Red Hat 5.x installation.

CAUTION: During the beginning of Windows Server

2003 installation, the

installer will automatically detect and possibly assign the default drive letter C

to USC and USC-LCE temporary storage device OEMDRV. Creating a new

Windows-bootable system partition on the hard-disk will assign the partition to a

drive letter other than C; this is standard Windows installer behavior. To assign

the new partition to C, see "Assign a Windows-Bootable System Partition to the C:

Drive" for more information.

NOTE: When the system reboots after you click Finish, you may be prompted to

press a key before booting to the operating system installation media. If you do not

press a key, the system boots to the hard-disk and not the operating system

installation media.

NOTE: In the event that the operating system installation is interrupted and the

system reboots before installation completes, you may be prompted to press a key

in order to boot from the operating system installation media.

NOTE: You can cancel the operating system installation by pressing the <F10> key.

Pressing the <F10> key at any point during the installation process or while

rebooting causes any drivers provided by the OS Deployment wizard to be removed.

NOTE: Microsoft Windows Server 2008 UEFI operating system installations are not

currently supported.

NOTE: After the operating system is installed, you cannot update USC or USC-LCE

by running a DUP in the operating system environment for the next 18 hours.

LC1_2.book Page 23 Wednesday, November 18, 2009 9:42 AM