White Papers

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Windows Version: 2.1.0
141
RebootRequired = Yes
ReturnValue = 0
SetResult = Set PendingValue
15.14 Setting CNA LAN Modes
The SetAttributes() method is used to set or change the values of a group of NIC attributes.
Invoke SetAttributes() with the following parameters (from Section 15.1) and syntax:
Target: FQDD attained through DCIM_NICEnumeration
AttributeName: Attained from AttributeName field
AttributeValue: A new value to assign to the specified NICAttribute. If this value is valid, it
will be applied to the PendingValue property or the Currentvalue property of the specified
NICAttribute. Possible choices are attained from PossibleValues field.
EXAMPLE:
winrm i SetAttributes http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService
?SystemCreationClassName=DCIM_ComputerSystem
+CreationClassName=DCIM_NICService
+SystemName=DCIM:ComputerSystem
+Name=DCIM:NICService
-u:[USER] -p:[PASSWORD]
-r:https://[IPADDRESS]/wsman -SkipCNcheck -SkipCAcheck
-encoding:utf-8 -a:basic -file:SetAttributes_NIC.xml
The input file SetAttributes_NIC.xml is shown below:
<p:SetAttributes_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService">
<p:Target>NIC.Embedded.1-1</p:Target>
<p:AttributeName>LegacyBootProto</p:AttributeName>
<p:AttributeValue>PXE</p:AttributeValue>
<p:AttributeName>LnkSpeed</p:AttributeName>
<p:AttributeValue>10Mbps Half</p:AttributeValue>
<p:AttributeName>WakeOnLan</p:AttributeName>
<p:AttributeValue>Disabled</p:AttributeValue>
<p:AttributeName>VLanMode</p:AttributeName>
<p:AttributeValue>Enabled</p:AttributeValue>
<p:AttributeName>IscsiTgtBoot</p:AttributeName>
<p:AttributeValue>One Time Disabled</p:AttributeValue>
</p:SetAttributes_INPUT>
OUTPUT:
SetAttributes_OUTPUT
Message = The command was successful
MessageID = NIC001