Web Services Interface Guide

Dell™ Lifecycle Controller 2 Web Services Interface Guide for Linux Version: 2.1.0
200
AttributeValue: Obtained from the PossibleValues field
EXAMPLE:
wsman invoke -a SetAttributes http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_RAIDService
?SystemCreationClassName=DCIM_ComputerSystem,
CreationClassName=DCIM_RAIDService,SystemName=DCIM:ComputerSystem,
Name=DCIM:RAIDService -h $IPADDRESS -V -v -c dummy.cert -P 443
-u $USERNAME -p $PASSWORD
-J SetAttributes_Enumeration_RAID_Controller.xml -j utf-8 -y basic
The input file SetAttributes_Enumeration_RAID_Controller.xml is shown below:
<p:SetAttributes_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_RAIDService">
<p:Target>RAID.Integrated.1-1</p:Target>
<p:AttributeName>RAIDloadBalancedMode</p:AttributeName>
<p:AttributeValue>Disabled</p:AttributeValue>
<p:AttributeName>RAIDBatteryLearnMode</p:AttributeName>
<p:AttributeValue>Warn only</p:AttributeValue>
<p:AttributeName>RAIDccMode</p:AttributeName>
<p:AttributeValue>Normal</p:AttributeValue>
<p:AttributeName>RAIDprMode</p:AttributeName>
<p:AttributeValue>Disabled</p:AttributeValue>
<p:AttributeName>RAIDcopybackMode</p:AttributeName>
<p:AttributeValue>SMART</p:AttributeValue>
</p:SetAttributes_INPUT>
OUTPUT:
<n1:SetAttributes_OUTPUT>
<n1:Message>The method was successful</n1:Message>
<n1:MessageID>STOR001</n1:MessageID>
<n1:RebootRequired>Yes</n1:RebootRequired>
<n1:ReturnValue>0</n1:ReturnValue>
<n1:SetResult>Set Pending Value</n1:SetResult> </n1:SetAttributes_OUTPUT>
16.19.3 Changing the Value of a RAID Controller Integer Attribute
The SetAttribute() method is used to set or change the value of a RAID controller integer attribute.
The example below shows setting an controller attribute.
Invoke the SetAttribute() method with the following parameters (from Section 16.1) and syntax:
TARGET: Obtained from the FQDD field
AttributeName: Obtained from the AttributeName field
AttributeValue: Obtained from the PossibleValues field