Service manual

Using the System Setup Program: Dell Latitude CP
speed to reduce or stop the vibration caused by the unbalanced CD.
NOTE: When this option is set to Variable, the CD-ROM drive takes several seconds
to determine the proper speed. You cannot access the disc during that time.
Internal Hard Drive
Internal Hard Drive displays the capacity of your computer's hard-disk drive. This option does
not have any user-selectable settings.
Keyboard Click
Keyboard Click lets you choose whether the built-in keyboard makes audible clicking sounds.
The Click Volume option must be enabled for this option to function. The volume of the
simulated key clicks is controlled by the setting in the Click Volume option.
Settings for this option are Disabled (the default) and Enabled.
A change to the Keyboard Click option takes effect immediately (rebooting is not required).
Modular Bay
Modular Bay identifies the kind of device-Diskette Drive, Battery, or CD-ROM Drive-that is
installed in the modular bay. If there is no device in the modular bay-or if a travel bay is
installed-this option reads Not Installed. There is no user-selectable settings for this option.
Microprocessor
Microprocessor displays the type and speed of the microprocessor installed on your
computer's system board. There are no user-selectable settings for this option.
Parallel Mode
Parallel Mode controls whether the computer's built-in parallel port acts as a PS/2-compatible
(Bidirectional) port, AT-compatible (Normal) port, or Extended Capabilities Port (ECP)-
compatible port. The default setting for Parallel Mode is ECP.
Windows 95 uses ECP protocol automatically if it detects an ECP-capable device.
Set this category according to the type of peripheral device connected to the parallel port. To
file:///I|/SERVICE%20MANUALS/DELL%20MANUAL...ES%20REF%20AND%20TROUBLESHOOTING/Setup.htm (15 of 21)6/21/2004 1:38:36 AM