Personal Computer User Manual

Appendix 177
4 Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5 Wait for approximately five seconds to clear the password.
6 Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3 to enable the password feature.
7 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
8 Connect your computer and devices to electrical outlets, and turn
them on.
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1 Follow the procedures in "Before You Begin" on page 99.
NOTE: The computer must be disconnected from the electrical outlet to clear
the CMOS setting.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3 Reset the current CMOS settings:
a Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system
board (see "System Board Components" on page 105).
b Remove the jumper plug from the CMOS jumper (CLEAR CMOS)
pins 2 and 3.
c Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1
and 2 and wait approximately five seconds.
d Remove the jumper plug and replace it on the CMOS jumper
(CLEAR CMOS) pins 2 and 3.
4 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).