Personal Computer User Manual
Table Of Contents
- Contents
- Finding Information
- Setting Up and Using Your Computer
- Front View of the Computer
- Back View of the Computer
- Installing Your Computer in an Enclosure
- Setting Up a Printer
- Playing CDs and DVDs
- Copying CDs and DVDs
- Using a Media Card Reader (Optional)
- Connecting Two Monitors
- Power Management Options in Windows XP
- Power Management Options in Windows Vista
- Enabling SpeedStep™ Technology
- About RAID Configurations
- Transferring Information to a New Computer
- Setting Up a Home and Office Network
- Connecting to the Internet
- Solving Problems
- Troubleshooting Tips
- Battery Problems
- Drive Problems
- E-Mail, Modem, and Internet Problems
- Error Messages
- Keyboard Problems
- Lockups and Software Problems
- Media Card Reader Problems
- Memory Problems
- Mouse Problems
- Network Problems
- Power Problems
- Printer Problems
- Scanner Problems
- Sound and Speaker Problems
- Video and Monitor Problems
- Troubleshooting Tools
- Removing and Installing Parts
- Appendix
- Glossary
- Index
152 Removing and Installing Parts
Processor
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
Removing the Processor
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
CAUTION: Despite having a plastic shield, the heat sink assembly may be very
hot during normal operation. Be sure that it has had sufficient time to cool before
you touch it.
3
Remove the processor fan/heat sink assembly from the computer (see
"Removing the Processor Fan/Heat Sink Assembly" on page 150).
NOTICE: Unless a new heatsink is required for the new processor, reuse the
original heat sink fan assembly when you replace the processor.
4
At the processor, place your finger upon the hook end of the release lever,
then push down and out to release it from the tab that secures it.