Personal Computer User Manual
Table Of Contents
- Contents
- Finding Information
- Setting Up and Using Your Computer
- Front View of the Computer
- Back View of the Computer
- Installing Your Computer in an Enclosure
- Setting Up a Printer
- Playing CDs and DVDs
- Copying CDs and DVDs
- Using a Media Card Reader (Optional)
- Connecting Two Monitors
- Power Management Options in Windows XP
- Power Management Options in Windows Vista
- Enabling SpeedStep™ Technology
- About RAID Configurations
- Transferring Information to a New Computer
- Setting Up a Home and Office Network
- Connecting to the Internet
- Solving Problems
- Troubleshooting Tips
- Battery Problems
- Drive Problems
- E-Mail, Modem, and Internet Problems
- Error Messages
- Keyboard Problems
- Lockups and Software Problems
- Media Card Reader Problems
- Memory Problems
- Mouse Problems
- Network Problems
- Power Problems
- Printer Problems
- Scanner Problems
- Sound and Speaker Problems
- Video and Monitor Problems
- Troubleshooting Tools
- Removing and Installing Parts
- Appendix
- Glossary
- Index
Removing and Installing Parts 143
Battery
Replacing the Battery
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer chassis.
A coin-cell battery maintains computer configuration, date, and time
information. The battery can last several years. If you have to repeatedly reset
time and date information after turning on the computer, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer’s instructions.
To replace the battery:
1
Record all the screens in system setup (see "System Setup" on page 170) so
that you can restore the correct settings in Step 11.
2
Follow the procedures in "Before You Begin" on page 99.
3
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
4
Remove the support bracket (see "Removing the Support Bracket" on
page 102).
5
Locate the battery socket (see "System Board Components" on page 105).
6
Carefully press the battery release lever away from the battery and the
battery will pop out.
7
Insert the new battery into the socket with the side labeled "+" facing up,
then snap the battery into place.