Personal Computer User Manual
Table Of Contents
- Contents
- Finding Information
- Setting Up and Using Your Computer
- Front View of the Computer
- Back View of the Computer
- Installing Your Computer in an Enclosure
- Setting Up a Printer
- Playing CDs and DVDs
- Copying CDs and DVDs
- Using a Media Card Reader (Optional)
- Connecting Two Monitors
- Power Management Options in Windows XP
- Power Management Options in Windows Vista
- Enabling SpeedStep™ Technology
- About RAID Configurations
- Transferring Information to a New Computer
- Setting Up a Home and Office Network
- Connecting to the Internet
- Solving Problems
- Troubleshooting Tips
- Battery Problems
- Drive Problems
- E-Mail, Modem, and Internet Problems
- Error Messages
- Keyboard Problems
- Lockups and Software Problems
- Media Card Reader Problems
- Memory Problems
- Mouse Problems
- Network Problems
- Power Problems
- Printer Problems
- Scanner Problems
- Sound and Speaker Problems
- Video and Monitor Problems
- Troubleshooting Tools
- Removing and Installing Parts
- Appendix
- Glossary
- Index
126 Removing and Installing Parts
Connecting and Disconnecting Drive Cables
When connecting and disconnecting a serial ATA data cable, disconnect the
cable using the pull-tab.
The serial ATA interface connectors are keyed for correct insertion; that is, a
notch or a missing pin on one connector matches a tab or a filled-in hole on
the other connector.
Hard Drives
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set
the drive on a surface, such as a foam pad, that will sufficiently cushion it.
NOTICE: If you are replacing a hard drive that contains data you want to keep,
back up your files before you begin this procedure.
Check the documentation for the drive to verify that it is configured for your
computer.
Removing a Hard Drive
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see"Removing the Computer Cover" on
page 101).
3
Remove the support bracket (see "Removing the Support Bracket" on
page 102).
4
Disconnect the power and data cables from the drive.
5
Disconnect the data cable from the system board.