Specifications

Memory Module, Modem, Optical Drive, and Floppy Drive: Dell Inspiron 2600 and 2650
Back to Contents Page
Memory Module, Modem, Optical
Drive, and Floppy Drive
Dell™ Inspiron™ 2600 and 2650
Memory Module
Modem
Optical Drive
Floppy Drive
Memory Module
Removing the Memory Module/Modem Cover
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by
touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the
following procedure.
HINT: This procedure covers removing and replacing the memory module
located under the memory module/modem cover on the bottom of the
computer. A second memory module resides on the upper surface of the system
board under the EMI shield. To replace the memory module under the EMI
shield, perform the procedure for removing the
EMI shield. Then replace the
memory module.
1. Turn the computer over, and remove the memory module/modem cover:
a. Remove the M2.5 x 5-mm screw from the memory module/modem cover.
file:///F|/Service%20Manuals/Dell/Inspiron/2600-50/upgrades.htm (1 of 18) [2/28/2004 6:52:41 AM]