Quick Reference Guide

Hard-Disk Drive Assembly
Figure 5. Hard-Disk Drive Assembly Removal
NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.
NOTICE: The hard-disk drive is very sensitive to shock. Handle the assembly by its edges (do not squeeze the top of the hard-disk
drive case), and avoid dropping it.
NOTICE: Make sure that the work surface is clean to prevent scratching the computer cover.
1. Turn the computer over, and remove the two M3 x 3-mm screws from the bottom of the hard-disk drive door (see Figure 5).
The hard-disk drive is located on the right side of the computer.
2. Pull the drive out of the computer.
Keyboard Bezel
1
Keyboard bezel
2
Right hinge cover
3
Hard-disk drive
4
Modem
5
System board assembly
6
Fan
7
Docking doors (not supported)
8
Bottom case assembly
9
Battery
10
Speaker
11
Audio I/O port cover
12
Audio EMI shield
13
Palmrest assembly
14
Keyboard
15
Left hinge cover
16
Display assembly
1
Hard-disk drive
2
M3 x 3-mm screws (2)