Service Manual
Table Of Contents
- Inspiron 14 5410 2-in-1 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 5410 2-in-1
- Base cover
- Battery
- Coin-cell battery
- Memory module
- Wireless card
- Solid-state drive
- Speakers
- Heat sink
- Display assembly
- Power-adapter port
- Touchpad
- Fan
- I/O board
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
- SupportAssist diagnostics
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- Built-in self-test (BIST)
- Recovering the operating system
- Flashing the BIOS
- Flashing BIOS (USB key)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
3. Remove the base cover.
4. Remove the battery.
5. Press and hold the power button for 20 seconds to drain the flea power.
6. Install the battery.
7. Install the base cover.
8. Connect the power adapter to your computer.
9. Turn on your computer.
NOTE: For more information about performing a hard reset, see the knowledge base article SLN85632 at
www.dell.com/support.
Troubleshooting 79