Service Manual
Table Of Contents
- Inspiron 14 5410 2-in-1 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 5410 2-in-1
- Base cover
- Battery
- Coin-cell battery
- Memory module
- Wireless card
- Solid-state drive
- Speakers
- Heat sink
- Display assembly
- Power-adapter port
- Touchpad
- Fan
- I/O board
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
- SupportAssist diagnostics
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- Built-in self-test (BIST)
- Recovering the operating system
- Flashing the BIOS
- Flashing BIOS (USB key)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Using the alignment posts, place the fan on the palm-rest and keyboard assembly.
2. Remove the two screws (M2x3) that secure the fan to the palm-rest and keyboard assembly.
3. Connect the fan cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
3. Exit Service Mode.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
About this task
The following image indicates the location of the I/O-board and provides a visual representation of the removal procedure.
Removing and installing components
47