Service Manual
Table Of Contents
- Inspiron 14 5410 2-in-1 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 5410 2-in-1
- Base cover
- Battery
- Coin-cell battery
- Memory module
- Wireless card
- Solid-state drive
- Speakers
- Heat sink
- Display assembly
- Power-adapter port
- Touchpad
- Fan
- I/O board
- Power button with optional fingerprint reader
- System board
- Palm-rest and keyboard assembly
- Device drivers
- System setup
- Troubleshooting
- SupportAssist diagnostics
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- Built-in self-test (BIST)
- Recovering the operating system
- Flashing the BIOS
- Flashing BIOS (USB key)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Peel the tape that secures the battery cable to the system board (applicable only if not peeled earlier).
2. Disconnect the battery cable from the system board (applicable only if not disconnected earlier).
3. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4. Lift the battery off the palm-rest and keyboard assembly.
Installing the 3-cell or 4-cell battery
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
18
Removing and installing components