Service Manual
Table Of Contents
- Inspiron 14 5410 2-in-1 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- SupportAssist diagnostics
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- Built-in self-test (BIST)
- Recovering the operating system
- Flashing the BIOS
- Flashing BIOS (USB key)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Align and place the system board on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x1.8) that secure the system board to the palm-rest and keyboard assembly.
3. Connect the display cable to the connector on the system board and close the latch to secure the cable.
4. Adhere the tape that secures the display cable to the system board.
5. Connect the power-adapter port cable to the connector on the system board.
6. Connect the keyboard-backlight cable into the connector on the system board and close the latch to secure the cable.
7. Connect the keyboard cable to the connector on the system board and close the latch to secure the cable.
8. Connect the touchpad cable to the connector on the system board and close the latch to secure the cable.
9. Connect the speaker cable to the system board.
10. Connect the I/O-board cable to the connector on the system board and close the latch to secure the cable.
11. Adhere the tape that secures the I/O-board cable to the system board.
12. Close the left display hinge.
13. Replace the two screws (M2.5x3.5) that secure the left display hinge to the system board and palm-rest and keyboard
assembly.
14. Align the screw holes on the USB Type-C port bracket with the screw holes on the system board.
15. Replace the two screws (M2.5x3.5) that secure the USB Type-C port bracket to the system board.
16. Adhere the tape that secures the USB Type-C port bracket to the system board.
17. Route the antenna cables through the routing guides on the system board.
Next steps
1. Install the fan.
2. Install the heat sink.
3. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
4. Install the wireless card.
5. Install the memory modules.
Removing and installing components
59