Service Manual
Table Of Contents
- Inspiron 14 5410 2-in-1 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- SupportAssist diagnostics
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- Built-in self-test (BIST)
- Recovering the operating system
- Flashing the BIOS
- Flashing BIOS (USB key)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Align the screw holes on the power button with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M1.6x2) that secure power button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O board.
2. Install the display assembly.
3. Install the fan.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
6. Exit Service Mode.
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the fan.
5. Remove the display assembly.
6. Remove the I/O board.
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of
the removal procedure.
Removing and installing components
51