Service Manual

ManualsBrandsDell Manuals3000 SeriesInspiron 13 7375 2-in-1

Table Of Contents

Inspiron 13 7000 2-in-1 Service Manual
Before working inside your computer
- Before you begin
- Safety instructions
- Recommended tools
- Screw list
After working inside your computer
Removing the base cover
- Procedure
Replacing the base cover
- Procedure
Removing the battery
- Prerequisites
- Procedure
Replacing the battery
- Procedure
- Post-requisites
Removing the solid-state drive
- Prerequisites
- Procedure
Replacing the solid-state drive
- Procedure
- Post-requisites
Removing the memory modules
- Prerequisites
- Procedure
Replacing the memory modules
- Procedure
- Post-requisites
Removing the coin-cell battery
- Prerequisites
- Procedure
Replacing the coin-cell battery
- Procedure
- Post-requisites
Removing the wireless card
- Prerequisites
- Procedure
Replacing the wireless card
- Procedure
- Post-requisites
Removing the speakers
- Prerequisites
- Procedure
Replacing the speakers
- Procedure
- Post-requisites
Removing the fan
- Prerequisites
- Procedure
Replacing the fan
- Procedure
- Post-requisites
Removing the heat sink
- Prerequisites
- Procedure
Replacing the heat sink
- Procedure
- Post-requisites
Removing the power-adapter port
- Prerequisites
- Procedure
Replacing the power-adapter port
- Procedure
- Post-requisites
Removing the power and volume-buttons board
- Prerequisites
- Procedure
Replacing the power and volume-buttons board
- Procedure
- Post-requisites
Removing the status-light board
- Prerequisites
- Procedure
Replacing the status-light board
- Procedure
- Post-requisites
Removing the touchpad
- Prerequisites
- Procedure
Replacing the touchpad
- Procedure
- Post-requisites
Removing the I/O board
- Prerequisites
- Procedure
Replacing the I/O board
- Procedure
- Post-requisites
Removing the display assembly
- Prerequisites
- Procedure
Replacing the display assembly
- Procedure
- Post-requisites
Removing the system board
- Prerequisites
- Procedure
Replacing the system board
- Procedure
- Post-requisites
- Entering the Service Tag in the BIOS setup program
Removing the keyboard
- Prerequisites
- Procedure
Replacing the keyboard
- Procedure
- Post-requisites
Removing the palm-rest assembly
- Prerequisites
- Procedure
Replacing the palm-rest assembly
- Procedure
- Post-requisites
Removing the display panel
- Prerequisites
- Procedure
Replacing the display panel
- Procedure
- Post-requisites
Removing the display back-cover and antenna assembly
- Prerequisites
- Procedure
Replacing the display back-cover and antenna assembly
- Procedure
- Post-requisites
Removing the camera
- Prerequisites
- Procedure
Replacing the camera
- Procedure
- Post-requisites
Removing the display cable
- Prerequisites
- Procedure
Replacing the display cable
- Procedure
- Post-requisites
Downloading drivers
- Downloading the audio driver
- Downloading the graphics driver
- Downloading the USB driver
- Downloading the chipset driver
- Downloading the network driver
System setup
- Boot Sequence
- Navigation keys
- BIOS overview
- Entering the BIOS setup program
- System setup options
Troubleshooting
- Flashing the BIOS
- Enhanced Pre-Boot System Assessment (ePSA) diagnostics
  - Running the ePSA diagnostics
- System diagnostic lights
- Flea power release
- Wi-Fi power cycle
Getting help and contacting Dell
- Self-help resources
- Contacting Dell

2 Peel o the pieces of tape that secure the touch-pad to the palm-rest assembly.

Figure 18. Disconnecting touch-pad cable

latch 2 touch-pad cable

3 tape (2)

3 Remove the screws that secure the touchpad to the palm-rest assembly.