Service Manual
Table Of Contents
- Inspiron 13 7000 2-in-1 Service Manual
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the memory modules
- Replacing the memory modules
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the fan
- Replacing the fan
- Removing the heat sink
- Replacing the heat sink
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the power and volume-buttons board
- Replacing the power and volume-buttons board
- Removing the status-light board
- Replacing the status-light board
- Removing the touchpad
- Replacing the touchpad
- Removing the I/O board
- Replacing the I/O board
- Removing the display assembly
- Replacing the display assembly
- Removing the system board
- Replacing the system board
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Removing the display panel
- Replacing the display panel
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Removing the camera
- Replacing the camera
- Removing the display cable
- Replacing the display cable
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Table 4. System setup options—Advanced menu
Advanced
PowerNow! Enable Enables or disables the SpeedStep(tm)
mode of the processor. Default: Enabled
Virtualization Allows you to enable or disable the
Virtualization technology.
Default: Enabled
USB Emulation Allows you to enable or disable the USB
emulation feature. This feature denes
how the BIOS, in the absence of a USB-
aware operating system, handles USB
devices. USB emulation is always
enabled during POST.
NOTE: You cannot boot any type
of USB device (oppy, hard drive,
or memory key) when this option
is o.
Default: Enabled
USB Powershare Allows you to enable or disable the USB
emulation feature.
Default: Enabled
USB Wake Support Allows you to enable USB devices to
wake the computer from standby or to
disable the USB wake support feature.
NOTE: If USB PowerShare is
enabled, a device connected to
the USB PowerShare connector
may not wake the computer.
Default: Disabled
SATA Operation Allows you to congure the operating
mode of the integrated SATA hard drive
controller.
Default: AHCI
Adapter Warnings Allows you to choose if the computer
should display warning messages when
107